Just found this nice Gcode to help you set up a filament change for multiple colors in a print at a certain layer. Quoted from the original site which is linked below. How to pause printing to switch filament Posted by carlos, 16 November 2015 3:47 pm In order to do multi color print with one extruder. …
Category Archives: 3D Printing
Nozzle Purge and Wiping Gcode
Found this useful little snippet of Gcode that can be added to the start of a print to make sure the nozzle is well primed and clean. Original post linked below. Purge and nozzle wipe starting gcode Posted by carlos, 2 September 2015 2:01 pm Use this gcode to purge and wipe filiment before printing. Simplified version …
3D Printed Antenna Radial Storage Spools
My larger multi-band antenna, a Wolf River Coil, comes with a trio of pre-cut radial wires to attach to the legs. No matter how carefully I roll them up into a tied off bundle, the next time I get them out and setup the antenna, I spend a significant amount of time untangling them. I’ve …